1. Manuals
  2. Brands
  3. Solo Manuals
  4. Paint Sprayer
  5. 442
  6. Original instructions manual

Solo 442 Original Instructions Manual

Battery backpack sprayer
Hide thumbs Also See for 442:
Table of Contents

Advertisement

Quick Links

Download this manual
Original instructions
Instruction manual
Important!
Read this instruction manual carefully
before first operation and strictly
observe the safety regulations!
Battery backpack
sprayer
70263
442
en
07/2021

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 442 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Solo 442

Summary of Contents for Solo 442

  • Page 1 Original instructions Battery backpack Instruction manual sprayer Important! Read this instruction manual carefully before first operation and strictly observe the safety regulations! 70263 07/2021...

  • Page 2: Ec Declarations Of Conformity

    3 EC declarations of conformity can be found on our homepage under: https://de.solo.global/de/content/12-service Product: Battery backpack sprayer SOLO Kleinmotoren GmbH, Industriestraße 9, 1 Wear parts D-71069 Sindelfingen, GERMANY The following wear parts are not subject to the declares that the following machine, in the...

  • Page 3: Safety Provisions

     The charger should only be used for charging DANGER! Non-observation of the original the original SOLO 18 V battery indoors. The operating manual may cause accidents charger must not be used for any other purpose, with injuries. such as charging other batteries! The appliance is not to be used by persons Wear the prescribed protective clothing.
  • Page 4 (including residues) in suitable  Charge the battery before installing it in the containers and return them to collection points device. Only an original SOLO charger with the specified by the municipal administration. appropriate nominal output voltage should be ...

  • Page 5: Work Clothing /Personal Protection Equipment (Ppe)

     When the battery has reached the end of its  Always stay within calling distance from other service life, dispose of it properly at the official persons that may provide help in emergency. collection points.  Take regular working breaks to prevent fatigue. ...

  • Page 6: Work Preparation

    7 Work preparation Fig. 1 Fig. 1a Fig. 1b a. Spray tank) Fig. 1a: Pull the spray tube holder (j) forward into b. Tank lid screwed to the filling socket (c) the correct position until the groove (y) engages in d.
  • Page 7 Assembly carrying belt 7.1 Assembly Fig. 5 Assembly of the spraying wand (h): Fig. 2  Start the cap nut (m) evenly and screw the spray tube with the O ring (16x3 mm) onto the hand valve (g) hand-tight without tools. ...
  • Page 8 7.2 Length adjustment of the carrying straps Fig. 7 Fig. 9 Pulling down the two strap ends with the large loop will tighten the carrying straps. Fig. 7a Pulling the clamping slide (o) upwards will loosen the carrying strap.  Thread the ends with the short loop (ca. 20 mm) of each carrying belt through the specified slits in the standing base (e).

  • Page 9: Charging The Battery

    7.3 Filling screen and intake screen Fig. 15 Fig. 13 Insert the battery into the charger diagonally from the top using the guide grooves until it clicks into The basket in the filling neck (c) of the liquid tank place. contains a filter screen (r).

  • Page 10: Installation Of The Battery

    Insert the battery with the side guide grooves (t) 9 Use of the device into the receptacle on the SOLO cordless device or charger until it clicks into place with an audible  Do not use the sprayer in wind or rain.

  • Page 11: Maintenance, Cleaning And Storage

    9.2 Ending spraying Spraying: With the hand valve (g) closed (hand valve not At the end of work, turn off the pump with the on-off activated), switch on the pump with the on-off push push button (v). button (v). The pump starts up briefly until pressure In order to depressurise the device, keep the spray has built up in the pressure chamber.
  • Page 12  Remove the intake screen (s) from the cleaned 10.3 Empty the spray tank and clean all the spray agent tank and clean with clean water and parts in the spray delivery system to the a soft brush. nozzle Fig. 14 Turn off the pump, depressurise the device, remove the battery, and store it securely.
  • Page 13 16.0 l [4.2 gal] Residual volume, (remaining liquid in tank that cannot be used) < 200 ml [6.8 oz] Pump system SOLO Diaphragm pump Operating pressure . 1 / 2 / 3 / 4 bar 14 / 29 / 43 / 58 psi Permissible operating temperature 4 –...

  • Page 16: Made In Germany

    Made in Germany SOLO Kleinmotoren GmbH Industriestraße 9 D-71069 Sindelfingen Postfach / PO Box 60 01 52 D-71050 Sindelfingen DEUTSCHLAND / GERMANY Tel.: +49 (0)7031 301-0 Fax: +49 (0)7031 301-202 info@solo-germany.com http://solo.global...

Table of Contents