Threading The Left Needle - Brother 884-B20 Owner's Manual

Threading the left needle

1. Slide the needle threader chenge switch <A>
to the "L" mark on the machine.
2. Run the thread in the sequence illustrated,
following the yellow color and the number next
to each threading point.
a) Pull the thread off the spool and directly up
through the thread holder 1 and the thread
holder 2 on the thread tree from back to front.
b) Hold the thread with your left and right hands,
then pass the thread through the thread guide
3 , and then pass the thread through the
tension disc 4 which is in the channel next to
the yellow thread tension dial.
c) Guide the thread down the channel and
across through the threading points 5 6
7 next to the yellow color marks following
the numerical order in the accompanying
illustration.
Two needles
NOTE:
Make sure the thread is through the left of the
separater <B>.
18
One needle
Using the needle threader
The needle can be threaded by one-touch
operation using the needle threader.
1. Lower the presser foot lifting lever 1 to lower
the presser foot.
2. Pull the end of the thread, which has been
passed through the needle bar thread guide
2 , to the left, then pass the thread through the
notch of the thread guide 3 , and then firmly
pull the thread from the front and insert it into
the slit of the thread guide disk 4 all the way.
NOTE:
Make sure that the thread passes the notch of
the thread guide 3 .
3. Cut the thread with the thread cutter 5 on the
left side of the machine.