Tool Change Step Execution - Daewoo TAPER 40 Operation Manual

3.7.2 Tool change step execution

For the inspection and trouble shooting of ATC unit, tool change sequence can be executed
by step, and the process is as followings.
3.7.2.1 CAM ATC
In case of the others including Mynx series, tool change sequence can be excuted by only
M-code and process is as followings.
3
6
8
9
11
Inspection/adjustment/maintenance
3. Operation
Step Operation
1 Check machine state
and interference
2 Check tool change condition
3 Select MDI operation mode with opeation mode
selection rotary switch
4 Down WAITING POT by M33 command
5 Execute SPINDLE ORIENTATION by M19 command
6 Select manual mode with manual/auto rotary switch
of ATC OP. devices
7 Switch to ATC MAINTENANCE MODE by M39
command
8 Select manual mode with operationm mode selec-
tion rotary switch
9 Rotate CHAGER ARM to desired direction with
CW/CCW button of ATC OP. devices
(Execute spindle tool clamp/unclamp at first, if
necessary)
10 Confirm tool changer arm in initial position
11 Select MDI operation mode with operation mode selec-
tion rotary switch
12 Execute SPINDLE OPERATION by M19 command
13 Execute tool change once by M41 command
14 Select ATC manual operation mode to auto
15 Check machine state and interference
3 – 25
Location Remark
Machine – Refer to precau-
tions/ instruction
manual
– Refer to 4.1
Main OP.
panel
NC Panel
ATC OP.
devices
NC Panel
Main OP. – Refer to machine
panel instruction manual
ATC OP. – When tool change
devices abnormally stop
– Check tool changer
arm motion
– Refer to 3.3.1.1
ATC – Refer to instruction
manual
Main OP. – Refer to instruc-
panel tion manual
ATC OP.
devices
Machine – Refer to precau-
tions/ instruction
manual
VMCTOPES8D51