Table of Contents
Advertisement
The screen can be cleaned with a soft cloth and finger marks can be wiped away
with pure alcohol.
Note
Do not use solvent such as turpentine or petrol as they will attack the screen
surface.
Anti-theft protection
The anti-theft coding of your navigation system prevents an operation of
the system after a voltage interruption, e.g. during a vehicle repair or after
theft. After disconnecting the battery, disconnecting the navigation
system from the on-board voltage of the vehicle and after a fuse failure,
the code must be entered before the vehicle can be used again.
Enter code
– If a keypad appears after switching on with the command to enter the
code, the unit can be unlocked by entering the correct four-digit code
number. The number of the possible attempts is shown in the bottom
screen line.
– Press a digit from
0
to
9
on the digit block displayed on the screen.
The digit is accepted in the entry line.
– After a four-digit order has been entered, the group of digits will turn
grey (inactive) and no further digits can be accepted in the entry line.
– Press
on the screen in order to delete the digits in the entry
Delete
line from right to left and thereby correct your input, if necessary.
– If the correct code number is displayed in the entry line, press
Code number
The code number can only be called up "online" via the Škoda system, as this guar-
antees even more effective anti-theft protection. Please contact your authorized
Škoda Service Partner, if necessary.
Incorrect code number
If an incorrect code is confirmed after entry of the code, the procedure can be
repeated twice. The number of possible attempts is shown in the bottom screen
line.
If the code number is entered incorrectly for the third time, the unit will be blocked
for approx. one hour. It is possible to enter again the safety code after one hour has
expired, when the unit and the ignition have been switched on.
If three invalid attempts are then made again, the navigation system will be blocked
again for an hour.
The cycle - three attempts, blocked for an hour - will continue to apply.
Note
The code is normally stored in the instrument cluster. This ensures that it is auto-
matically decoded (convenience coding). Manual input of the code is normally not
necessary.
OK
.
General information
5
Advertisement
Table of Contents
