Table of Contents
Advertisement
1.
Make sure all breakers are in the "OFF" position on the dimmer pack.
2.
Apply power to the pack. The power indicator should be on. If control console is hooked up and running, the signal
indicator will also be on.
3.
Turn on the Test Switch.
4.
Confirm that the fan is running. If you are using a Universal Control Module, the fan should turn on when power is
applied.
5.
Turn on each dimmer breaker individually (one at a time) and confirm that each of the dimmers is working.
6.
Turn off the Test Switch.
7.
Turn on all dimmer breakers.
8.
Close the front door of the pack. The door should latch closed. Move the retaining bracket on the right edge of the
pack to the left and secure with the two thumb screws.
(Note to Canadian users: CSA requires screwdriver-installed screws in lieu of thumb screws. Two 8-32 x 1/2 screws are
provided for this purpose.)
9. Test the dimmers using control console.
THIS COMPLETES THE INSTALLATION OF THE TOPAZ 12 PACK DIMMING SYSTEM. IF THERE ARE ANY
TECHNICAL QUESTIONS OR DIFFICULTIES, SEE CHAPTER VIII: TROUBLESHOOTING.
CHAPTER V: FINAL ASSEMBLY
Page 17
Figure 11 - Assembled Pack
Hide quick links:
Advertisement
Table of Contents
