Advertisement
Single-Pole Wiring Application using 3-Way
Step 5b
Dimmer (Cat. No. 6633-L):
This wire is used in 3-way installations only.
For single pole installations, do not remove this insulating label.
Red
Neutral
Red
Ground
Green
Black
Dimmer
Hot (Black)
Black
Red
Insulating
Label
Red
Line 120VAC, 60 Hz
Green Ground
Neutral (White)
Connect wires per WIRING DIAGRAM as follows:
Screw wire nuts on clockwise making sure no bare
conductors show below the wire connectors. Secure each
connector with electrical tape.
•
Green dimmer Ground lead to Green or bare copper
wire in wall box.
•
Black dimmer lead to any wall box wire removed
from old switch.
•
Red dimmer lead without insulating label to remaining
wall box wire.
•
Remaining Red dimmer lead should have Red insulation
label affixed. Proceed to Step 6.
NOTE: If insulating label is not affixed to Red lead, use
a small wire nut or electrical tape to cap off. Proceed to
Step 6.
3-Way Wiring Application (Cat. No. 6633-L):
Step 5c
Neutral
Red
Red
Ground
Green
Black
Tag
Connect wires per WIRING DIAGRAM as follows:
Screw wire nuts on clockwise making sure no bare
conductors show below the wire connectors. Secure each
connector with electrical tape.
Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and proper use for two years from the purchase date. Leviton's
only obligation is to correct such defects by repair or replacement, at its option, if within such two year period the product is returned prepaid, with proof of purchase date, and a description of the problem to Leviton Manufacturing Co., Inc., Att: Quality Assurance
Department, 59-25 Little Neck Parkway, Little Neck, New York 11362-2591. This warranty excludes and there is disclaimed liability for labor for removal of this product or reinstallation. This warranty is void if this product is installed improperly or in an improper
environment, overloaded, misused, opened, abused, or altered in any manner, or is not used under normal operating conditions or not in accordance with any labels or instructions. There are no other or implied warranties of any kind, including merchantability and
fitness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warranty, including merchantability and fitness for a particular purpose, is limited to two years. Leviton is not liable for incidental,
indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment, lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this
warranty, whether based on contract, tort or otherwise.
• Green dimmer Ground lead to Green or bare copper
wire in wall box.
• Black dimmer lead to tagged (common) wall box wire
identified when removing old switch.
• Remove Red insulating label from Red lead.
Insert wires
• Any Red dimmer lead to any of the remaining wall box
straight then
wires.
twist
• Remaining Red dimmer lead to remaining wall box wire.
clockwise
Hot (Black)
Electrical
Line
Tape
120VAC, 60Hz
Neutral (White)
Testing your Dimmer prior to mounting in wall
Step 6
box:
Black
NOTE: This device is shipped with the indicator light enabled
Load
(On). If you do not want the light option (Off), with an insulated
screwdriver slide the switch at the TOP of the frame to the right
White
while facing the device before mounting wallplate.
Cat. No. 6631-L
Indicator
Slide Switch
Insert wires
Dimmer Mounting:
Step 7
straight then
twist
TURN OFF POWER AT CIRCUIT BREAKER OR FUSE.
clockwise
TOP
Electrical
Tape
LIMITED 2 YEAR WARRANTY AND EXCLUSIONS
Common
Dimmer
3-Way Switch
Terminal
(Black Screw)
Black
Red
Black
Red
Load
Green
Green
Ground
Ground
White
Cat. No. 6633-PL
• Restore power at circuit
breaker or fuse.
Indicator
• Carefully holding
Slide Switch
Dimmer as shown
proceed as follows:
For Cat. No. 6631, slide
control lever up to
highest position. Lights
should turn ON to
brightest level.
For Cat. No. 6633, slide
control lever to highest
postion. If lights are not
ON, press rocker. Lights
should turn ON to
brightest level.
If lights do not turn
ON, refer to the
TROUBLESHOOTING
section.
Installation may now be
completed by carefully
positioning all wires to
provide room in wall box for
dimmer. Mount dimmer
into box with mounting
screws supplied. Attach
®
Decora
wallplate.
Restore Power:
Step 8
Restore power at circuit breaker or
fuse. Installation is complete.
OPERATION
NOTE: If using the indicator light option, the light will illuminate when
the dimmer is in the OFF position to facilitate access in the dark.
NOTE: If using the dimmer in a 3-way application, the lights will
turn ON at brightness set on dimmer's slide control lever. The
lighting level can be controlled from either the dimmer or the
switch location.
Cat. No. 6631-L
Cat. No. 6633-PL depicted
ON: Slide control lever up to turn lights ON at
desired level of light.
OFF: Slide control lever all the way down until it
TOP
clicks to turn lights OFF.
BRIGHTEN: Raise slider control lever.
DIM: Lower slider control lever.
Cat. No. 6633-PL
ON: Push rocker switch ON.
OFF: Push rocker switch ON.
BRIGHTEN: Raise slider control lever to
desired level of light.
DIM: Lower slider control lever.
TROUBLESHOOTING
• Lights Flickering
- Lamp has a bad connection.
- Wires not secured firmly with wire connectors.
• Light does not turn ON and ON/OFF LED does not turn ON
- Circuit breaker or fuse has tripped.
- Lamp is burned out.
- Lamp Neutral connection is not wired.
NOTE: If further information is needed in identifying the HOT wire in a
3-Way application, go to Leviton's website at www.leviton.com.
For non-standard wiring applications, refer to
Wire Nut and Connector Size Chart
WIRE CONNECTOR / # OF COND.
COMBINATION CHART
1- #12 w/ 1 to 3 #14, #16 or #18
2- #12 w/ 1 or 2 #16 or #18
1- #14 w/ 1 to 4 #16 or #18
2- #14 w/ 1 to 3 #16 or #18
PK-93181-10-00-2A
Hide quick links:
Advertisement
