Battery Charging - Qutek MagiCure QMN20 Manual

Table of Contents

Advertisement

Only the electrode pads provided for the massager (40 mm wide,
40 mm high, and 2.0 mm thick) are suitable for use.
Please dispose of the waste electrode pads according to your local
environmental regulations.
It is recommended to use the massager once or twice a day; 15
minutes of electric impulse mode and 15 to 30 minutes of thermal
moxibustion.
. 9
Use of Button Cell of Remote Control:
The remote control adopts a CR2032 button cell, which can be
used for about 3 months (30 min each day).
The dim LCD backlight brightness and insensitive remote host
button indicate low battery capacity. Replace it with a new one.
Take out the battery when the product is not in use to prevent
battery leakage and machine fault.
Use the specified battery only.
Do not misplace positive and negative electrodes of the battery
with positive up and negative down.
Using the battery at a temperature above °45 C may influence the
battery›s properties and life.
The used battery should be disposed of as per urban environment
protection regulations.

Battery Charging:

. 1
When the buzzer beeps three times continuously during a
massage, it means the built-in lithium battery is running low and
needs adapter charging.
. 2
Shift the toggle switch to the «Charge» position, so the power
indicator turns green and flickers. When it is fully charged after
about 2 hours, the flickering will stop.
. 3
A fully charged battery lasts for about 5 days with twice a day
usage.
. 4
Under normal use, the rechargeable battery supports 500 times of
charging and discharging and lasts about 2 to 3 years (when used
twice a day for 30 minutes each).
. 5
Charge the battery to full once a month for extended service life.

Advertisement

Table of Contents
loading

Table of Contents