Table of Contents
Advertisement
Installation Diagram
Mode 1:
auto-combination mode 1
Mode 2:
auto-combination mode 2
Mode 3:
Scratch
Shiatsu ( Massage Mode)
Mode 4:
Rolling (
Mode 5:
Beating ( Scrating)
Mode 6:
The first two modes are manual, which will switch on automatically once
every minute between each other. Hence, it is suggested to use the
auto-combination mode.
. 5
Use of "+" Button:
When the massager starts up, the intensity will be Grade 0. It will
increase by one grade each time you press this button on the left
handle. There are 16 grades in total. Low intensity is recommended
for first use.
. 6
Use of "-" Button:
This button will reduce intensity by one grade with each pressing.
There are 16 grades in total.
. 7
Use of heat button:
This button is for choosing between 3 different heat modes: low
heat (1), Middle heat or default mode (2), High heat (3). You can stop
the heat by switching to (0) mode.
. 8
Use of Electrode Pads (optional):
•
Insert one of the two core connector wires into the electrode port
and connect the other end to the electrode pads. Then, use the
massager as specified above. If used with conductive plates, there
will be a little difference in intensity.
•
The electrode pads should be clean on their surfaces for optimal
viscosity. If dirty, flush with clean water and dry before using it.
•
It can be used 80 times (20 minutes each time). If appropriate
viscosity isn't recovered after several times of cleaning, consider
purchasing new ones.
Advertisement
Table of Contents
