Table of Contents
Advertisement
Operation Manual / TPL76-C
8 Disassembly and assembly / 8.5 Removing cartridge group
8.5 Removing cartridge group
Check dimension (u) [mm]
© Copyright 2018 . All rights reserved.
CAUTION
Locked safety segments (76080) during disassembly
Observe the maximum tightening torque for the nuts (90458) so as not
to shear off the threaded studs of the safety segments (76080).
Fit four nuts (74027) complete with washers (74018), equally spaced
u
around circumference, and tighten.
Remove insulation (from bearing casing).
u
Removing safety segments / releasing casing
Take nuts (90458) out of toolbox and screw them onto threaded
u
studs of safety segments (76080) on internal part of compressor cas-
ing (76000).
Tighten nuts (90458) to a maximum torque of 30 Nm.
u
The internal part of the compressor casing (76000) has now been separ-
ated from the external part (74000) and can be removed.
NOTICE
Note the control dimension (u).
Dimension
u
HZTL2485_EN
TPL76-C
21.8
Revision F
April 2018
Advertisement
Table of Contents
