Table of Contents
Advertisement
Operation Manual / TPL76-C
8 Disassembly and assembly / 8.5 Removing cartridge group
© Copyright 2018 . All rights reserved.
Removing the cartridge group
Unplug cable connector (86515) and unscrew speed sensor (86505)
u
with O-ring (86506).
Disconnect oil inlet and oil outlet pipes.
u
CAUTION
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be
ensured that the orifice plates that are specified for the turbocharger
have been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.
u
Version with compressor wheel cooling system
Remove air supply line. (See also chapter entitled Preliminary re-
u
marks / Layout and functionality)
HZTL2485_EN
Revision F
April 2018
Advertisement
Table of Contents
