Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Caple T80BUCHSS3
Summary of Contents for Caple T80BUCHSS3
- Page 1 INSTALLATION AND OPERATING INSTRUCTION BOOKLET T80BUCHSS3 BUILT UNDER COOKER HOOD IMPORTANT: You must read this instruction Book before installing or using this appliance and retain it for future use. Caple Products Telephone 0870 2411142 Facsimile 0117 982 6878 Page T60-80 Extractors.doc...
-
Page 2: Table Of Contents
YOUR NEW COOKER HOOD Dear Customer These instructions are designed to help you get to know your new cooker hood quickly and to achieve the best possible results. It is most important that this instruction book should be retained with the appliance for future reference. -
Page 3: Installer
SAFETY WARNINGS These warnings are provided in the interests of safety. Ensure you read and understand them before installing using this appliance. appliance such as a central heating boiler then it’s flue must be of the room INSTALLER sealed or balanced flue type. •... -
Page 4: Electrical Connections
Pressure Part 4, fitted with a 3A fuse is a Input W recommended mains supply connection Noise Level accessory to ensure compliance with the Safety Requirements applicable to fixed T60BUCHSS3 and T80BUCHSS3 wiring instructions. POWER CONSUMPTION Total 220W This appliance... -
Page 5: General
INSTALLATION INSTRUCTIONS GENERAL POSITIONING Please ensure that when the appliance is This cooker hood has been designed for installed it is easily accessible to an use fixed into a chimney housing, which engineer in the event of a breakdown. should constructed from fire... -
Page 6: Fixing The Cooker Hood Into The Canopy
T60BUCHSS3 for each 90° bend installed in the run). (677mm wide by 259mm deep) for the T80BUCHSS3 and check the positioning RECIRCULATION (FILTERED) of the hole is correct with the drawing in If you are using the cooker hood for fig. -
Page 7: Electrical Connection
OPERATING INSTRUCTIONS CONTROLS T60IT80BUCHSS3 FAN SWITCHES The cooker hood is designed to extract The switch (M) marked with the fan unpleasant odours from the kitchen, it will symbol and numbered 0-1 controls the not extract steam. power to the fan. ELECTRICAL CONNECTION Position-0 indicates the fan is switched OFF. -
Page 8: Electrical Connection
MAINTENANCE AND CLEANING WARNING: SWITCH SYNTHETIC GREASE FILTER COOKER HOOD SUPPLY The synthetic paper grease filter cannot CONNECTION UNIT BEFORE be cleaned and must not be washed. CARRYING KIND The filter should be replaced at least every MAINTENANCE OR CLEANING. three months or more frequently if the hood is used for more than three hours a WARNING:... -
Page 9: Before Calling Aservice Engineer
SERVICE REQUESTING SERVICE ENGINEER In the event of your cooker hood requiring service telephone Caple Service on: We strongly recommend that you carry out the following checks on your appliance 0870 241 1142. before calling a Service Engineer. It may... - Page 10 Page T60-80 Extractors.doc...
- Page 11 Page T60-80 Extractors.doc...
- Page 12 Page T60-80 Extractors.doc...
- Page 13 Page T60-80 Extractors.doc...
- Page 14 Page T60-80 Extractors.doc...