Advertisement
TEMPORARY & PERMANENT ANCHORING
PLEASE NOTE:
It is essential to firmly anchor yourEasyShed immediately following installation,
otherwise there is a risk of damage to panels, property or persons resulting from
sudden wind gusts. Select a level site and proceed as follows:
Method A Garden sheds may be anchored to an approved existing concrete
slab using the concrete fixing set (anchor brackets and bolts purchased separately)
Method B (recommended): A rebated concrete slab as shown below will prevent
water entry under the walls of the shed.
DIAGONAL MEASUREMENTS
MUST BE EQUAL
PERIMETER
BOXING
�
- 50 X 25 REBATE BOXING
E
· E
·o
....
0
Using a 10mm diameter masonry drill, position the bracket and drill a 60mm deep
anchor hole in the concrete. Insert the masonry anchor through the bracket
into the anchor hole until the anchor nut is firmly seated against the bracket.
Tighten the anchor nut with a spanner to attain maximum strength.
MODEL: EF-D3008
ANCHOR
SET
. L
F7� MESH WITH .. ·
· 30mm TOP COVER
EasyShed
METHOD'C'
••• · • • • · • · • · • ·
··• · • · ··• · ··• ·
c--
Cs:::�
Drive galvanized anchor
pegs into the ground
with the hook fastened
over the bottom channel
for short term temporary
anchoring.
WALL
---- DRILL A 10mm HOLE
THROUGH THE WALL PANEL AND
SECURE NUT/BOLT
®
·· • ··· • . ·•• · · ·••· · ·•
' '
�
Page7
Advertisement
