Step 4 Door Assembly - EasyShed EF-D3008 Assembly Instructions Manual

'
-Isa
'/)-J Ir)
"'
()
:x;fJ:'
�
Once the hinges are fitted
to the door channel, the
door channel part number
will have the letter 'H' added
to it as shown below.
C1740>>C1740H
This will make it easier to
identify the hinged door
channel in following
door assembly steps.
4.2 Repeat Step 4.1 for a second C1740 channel.

STEP 4 DOOR ASSEMBLY

FITTING THE HINGES
4.1 Position both sides of the hinge against the channel,
150mm in from each end, with the hinge pin exposed
__ _______, as shown. Drill 2 x 3mm holes through the two existing
hinge holes into the channel, then fasten with two rivets
as shown.
HINGE PIN THIS SIDE
MODEL: EF-D3008 | PAGE 12
-------l ► ►E
LOWER
SIDE
HIGHER
SIDE