Instrument Control Panel - Ferris ISX800 Series Operator's Manual

10
To raise the seat plate, release the latch by moving the seat
latch towards the front of the unit and then raise the seat
plate.
The seat latch is spring loaded. When the seat plate is
lowered back into place the seat latch will lock the seat plate
into place.
Fuel Tank Cap: To remove the cap, turn counter-clockwise.
Removable Floor Plate: The floor plate can be removed for
easy access to the mower deck. To remove the plate, remove
the retainer hardware and tilt the floor pan up and then
remove from the unit. Reverse the process for re-installation.
Transmission Release Levers:
Symbols
Each transmission is equipped with a transmission release
lever. These levers deactivate the transmissions so that the
unit can be pushed by hand. Both transmission release levers
must be in the same position whether you are driving the
unit or pushing it by hand. See Pushing the Unit by Hand for
operational information and control location.
Transmission Oil Fill: Transmission oil is added through the
hydraulic oil tanks. It also serves as extra holding capacity
for oil as the transmissions heat up and the hydraulic oil
expands. See Check / Fill Transmission Oil for oil level check
and fill procedures.
Control Name
Transmission Release Levers

Instrument Control Panel

Models with Carbureted Engines:
11
A. Choke
B. PTO (Power Take Off) Switch
C. Ignition Switch
D. Throttle Control
E. Hour Meter
Models with Fuel Injected Engines and Electronic
Throttle Control (ETC):
12
A. PTO (Power Take Off) Switch
B. Ignition Switch
C. Hour Meter
D. Throttle Control Rocker Switch
E. Malfunction Indicator Lamp (M.I.L.)
Choke: Close the choke for cold starting. Open the
choke once the engine starts. A warm engine may not require
19