2
SAFETY
To avoid personal injury and/or material damage, please read the following safety instructions and
follow them at all times:
• This manual is part of the product. It must be read and followed.
• As the operator of the electrical system, keep the manual accessible at all times or, as the in-
staller, hand over the document to the operator of the electrical system after successful installa-
tion and commissioning.
• Damaged products must neither be installed nor put into operation.
• Protective measures and mechanisms must correspond to applicable regulations.
• All international, national and regional guidelines, standards, safety instructions and safety reg-
ulations must be observed throughout the entire life cycle of the product.
• Never use components from third-party manufacturers. No guarantee shall be offered for dam-
age resulting from a combination with third-party components.
• The name plate must not be removed and must be permanently attached to the distribution
box.
• This distribution box has been designed, produced and tested in accordance with the applica-
ble safety requirements. Despite the greatest care, it can pose a safety risk - as can all electro-
technical/ electronic components and products.
2.1
Intended use
Observe the technical data of your distribution box for information on the intended use. Refer to
chapter 6 "Technical data", p. 11.
2.2
CE declaration
You can find the relevant CE declaration at:
below. Navigate to the download area of your product. You will then find the CE declaration under
the item "EC Declaration of Conformity".
Wieland Electric GmbH | BA001298 | 09/2022 (Rev. A)
https://eshop.wieland-electric.com
Safety
or via the QR code
7