Bosch BDU336Y Owner's Manual page 136

Securing on the handlebars (see figure C)
C
(4)
(3)
(5)
(3) Clamp for holder
(4) Clamp screw
(5) Round rubber spacer
(6) 1-arm socket
(7) Screw for adjusting tilt
Note: The display holder must only be secured in the
cylindrical area of the handlebars and not in the ta-
pered area. To clamp a display in the center, the han-
dlebars must have a cylindrical area of at least 90 mm
in width.
Open the clamp and bring the 1-arm socket (6), to-
gether with the round rubber spacer (5), into the re-
quired position. Gently tighten the clamp screw (4)
so that the 1-arm socket (6) can still move.
Adjust the tilt for the display mount by loosening and
tightening the screw (7). Preferably adjust the tilt
without the display or on-board computer.
In the connection between the 1-arm socket (6) and
the adapter tray, there are interlocking teeth, which
means that it is only possible to align the adapter tray
in predefined positions. Before tightening the
screw (7), make sure that the teeth engage in one an-
other correctly. In addition, be aware of the torque
specified on the 1-arm socket (6).
Bring the 1-arm socket (6) into its final position and
tighten the clamp screw (4). Be aware of the torque
specified on the 1-arm socket (6) here too.
Thanks to the round rubber spacer (5), it is possible
to move the 1-arm socket (6) in all directions.
Bosch eBike Systems
Removal blocker
A device attached to the display holder can be se-
(5)
(7)
cured using the removal blocker (8). Usage is de-
scribed in the operating instructions for the respec-
tive device.
(6)
English – 7
0 275 U07 3S1 | (08.06.2021)