Advertisement
Loading Cut Sheet Media
Some information in the Paper Handling section of the User's Guide and in the Loading the Cut Sheet
Media section of the Unpacking and Setup Guide, has been changed as described below.
To load A4, Letter or 8 × 10 inch cut sheet media, see "Loading cut sheet media with a size of A4, Letter
or 8 × 10 inches" on page 6.
If you are printing on thick paper (0.5 to 1.5 mm), see "Printing on thick paper (0.5 to 1.5 mm)" on page 7.
Loading cut sheet media longer than A3 or Legal
To load cut sheet media longer than A3 or Legal, follow the steps below.
c
Caution:
As much as possible, keep your fingers off the printable surface of the media, as fingerprints may reduce
printout quality.
1. Make sure that the printer is on and the roll paper cover is closed.
2. Press the Paper Source l button repeatedly until Sheet
3. Make sure that the Power light is not flashing, and then set the paper lever to the released position.
LEVER RELEASED. LOAD PAPER appears on the LCD panel.
c
Caution:
Do not set the paper lever to the released position while the Power light is flashing; otherwise, damage
may occur.
4. Load the sheet into the paper insertion slot until it comes out below. Make sure that the right and
bottom edges of the sheet are straight and in line with the horizontal line and the vertical line.
appears.
5
Advertisement
