|
Back
4
Back
Roll holder
Loading Media
Before you start, make sure the printer is turned on. Follow these steps to use the built-in media feeding
unit. If you are using the optional heavy roll media system, see the online User's Guide for instructions.
The illustrations in this manual show various products, but the instructions apply to all three models
unless otherwise noted.
WARNING: The heaters and media holding plates may be hot; be careful to avoid burns. Heavy media rolls may
require two people for loading and removing.
Caution: Load media immediately before printing to avoid creases and curling.
Open the front cover and move the media holding plates out of the way.
1.
Drive switch
Roll locking
screw
Lift lever
Pre-heater
Roll support
Handle