Levita LT61B Operator's Manual page 88

5.4.7 Unblocking the collector channel
the collector channel gets blocked (due to accumulated grass cuttings filling up the grass-
catcher or an excessively high speed with relation to the quantity of grass cuttings), you need
to:
1. stop forward movement immediately, disengage the blade and stop the engine;
2. remove the grass-catcher;
3. remove the accumulated cuttings, reaching them from the exit of the collector channel.
5.4.8 End of mowing
When you have finished mowing, disengage the blade, lower the engine speed and ride the
machine with the cutting deck in the highest position.
5.4.9 End of work
Once you have finished mowing, stop the machine and engage the parking brake.
1. shift the accelerator lever to «SLOW»;
2. switch off the engine by turning the key to «STOP».
position before leaving the machine unattended!
5.4.10 Cleaning the machine
After each mowing, clean the outside of the machine, empty the grass-catcher and shake it to
remove residual grass and earth.
containers full of cut grass inside a room.
Clean the plastic parts of the body with a damp sponge using water and detergent, taking care
not to wet the engine, the electrical parts or the electronic card located under the dashboard.
body and engine!
This job must only be performed with the engine Turned off. If
Always take out the ignition key before leaving the machine
unattended
To keep the battery charged, do not leave the key in the«ON»
position when the engine is not running.
Always make sure that the accelerator level is in the «OFF»
Always empty the grass-catcher and do not leave
Never use hose-nozzles or harsh detergents for cleaning the
-88-