Levita LT61B Operator's Manual page 78

4.3 PARKING BRAKE LEVER
This lever stops the machine from moving when it has been parked.
There are two positions:
B
4.4 SPEED CHANGE LEVER
3 2
4
4.5 CUTTING HEIGHT ADJUSTING LEVER
another, move the lever sideways and put it back in one of the stop notches.
A
1 N
R
Reverse must be engaged when the machine has stopped.
4.5
−
The brake is engaged by pressing the
pedal (☛4.2) right down and moving the
lever to position «B».
When you take your foot off the pedal
it will be blocked by the lever in the
down position.
−
To disengage the parking brake, press
the pedal(☛4.2).The lever will return to
position «A».
This lever has six positions for the four
forward gears, the neutral position «N», and
reverse «R».
– To change gear, press the pedal (☛4.2)
halfway down and move the lever as per
the indications on the label.
There are five positions for this lever,
shown as «1» to «5» on the plate,
which correspond to various cutting
heights from 3.5 to 7.5 cm.
– To go from one position to
-78-