Using The Machine - Levita LT 61 Operator's Manual

5.4 USING THE MACHINE

5.4.1 Starting the engine
well-ventilated area! ALWAYS REMEMBER THAT EXHAUST GASES ARE TOXIC!
To start the engine:
1. sit on the seat and press the brake pedal right down(☛4.2);
2. put the transmission into neutral («N») (☛ 4.4);
3. disengage the blade (☛ 4.6);
4. for cold starting, put the accelerator lever in the «CHOKE» position (if fitted) as shown on
the label (☛ 4.12 ).
Alternatively, if the engine is still hot or without a choke, position the lever between
«SLOW» and «FAST»;
5. put in the key (☛ 4.11) and turn to «ON» to make electrical contact, then turn to «START»
to start the engine;
6. release the key once the engine has started;
Using it when the engine is already warm can foul the spark plugs and cause the engine to
run erratically.
to avoid flooding the engine or running down the battery (if present).
−
Check that the conditions allowing the engine to start are met
−
Turn the key (electric start) to «OFF». Wait for a few seconds and repeat the start
operation. Should the malfunction persist, refer to chapter «8» of this manual and the
engine manual.
5.4.2 Starting and moving without mowing
It has to be used (as indicated by the Highway Code) in private areas closed to traffic.
and the cutting deck put at its highest position.
To start the forward movement:
1. put the accelerator control between the «SLOW» and «FAST» positions;
2. push the pedal right down (☛4.2) and put the gear change lever in 1st gear (☛4.4).
3. release the pedal gradually to begin the movement.
Reach the desired operating speed using the accelerator and gear lever. To change gear, the
clutch must always be used by pushing the pedal (☛4.2).
all starting operations have to be effected in an open or
The choke (if fitted) must be closed as soon as possible.
If you have difficulty starting, do not make several attempts
this machine has not been approved for use on public roads.
When moving the machine, the blade must be disengaged
-85-