Levita LT 61 Operator's Manual page 76

3.4 FITTING THE BLADE ENGAGEMENT LEVER
3
3.5 CONNECTING THE BATTERY
1
2
Avoid short circuiting!
Beware of fire, explosion or burns.
Do not disassemble the battery or heat it up above 55°C, and do not dispose of it in a fire!
Note that the battery electrolyte is a solution of sulphuric acid; when it comes into contact
with skin wash it with large amounts of water. In case of eye contact seek medical attention.
Store the battery out of reach of children!
handling and disposal.
3.6 FITTING THE GRASS-CATCHER
Identify the screws to be used by following the drawing that shows them in their actual Size
2
1
2
fit the end of the lever (1) on the projecting
part of the pin (2) and fix it all by tightening
the screw (3) and nut (4)
4
3
Never start the engine until the battery is fully charged!
Follow the battery manufacturer's instructions regarding safe
1
1. Position the battery (1) in its
compartment under the seat;
2. Connect the battery connector (2) to
the machine connector (3);
3. Recharge the battery by following the
instructions in the Manual(☛6.2.3).
Fit the two tie rods (1) and fasten them by using the
screws (2)
-76-