Advertisement
Quick Links
Advertisement
Related Manuals for Franke medi-flo HWSS2321W-00
Summary of Contents for Franke medi-flo HWSS2321W-00
- Page 1 INFECTION CONTROL WASH BASIN...
- Page 2 Medi-flo is recommended to be installed with a thermostatic mixing valve and set to a temperature of 27-38C. (Optional accessory MEDI-MIX is available from Franke.) Franke Medi-flo sink is designed to install on provided wall hanger brackets. If mounting on a wall that cannot support the load, we recommend the use of our FRANKE in-wall carrier IWC2104.
- Page 3 HWSS2321W-00 WALL OPENINGS LAYOUT 7 [178 mm] 3 1/2 [89 mm] 2 [51 mm] 10 3/8 [263 mm] 8 11/16 [220 mm] 3 1/4 [83 mm] Opening for rough in box 32 13/16 [833 mm] 31 9/16 [801 mm] GFI Plug Location 21 1/4 [539 mm] 19 1/4 [489 mm]...
-
Page 4: Electrical Connections
HWSS2321W-00 MOUNT SINK Hang sink onto wall brackets and level the sink by eye. (Final levelling will take place after water flow is activated. INSTALL THE WASTE FITTING INTO THE SINK. a. Disassemble the waste fitting. b. Slide the waste body and upper gasket into the sink hole. c. -
Page 5: Water Connections
Insert the other side into the bottom of the laminar flow chamber. d. If using a thermostatic mixing valve (Franke MEDI-MIX sold separately), recommended temperature is 27-35 ∘ C (80-95 F) (Hot or warmer water is both harsher on the user’s skin and secondly, as water temperature increases, it loses its ability to dissolve ozone which can cause reductions in sanitization performance.) When adjusting the thermostatic mixing... - Page 6 HWSS2321W-00 Once the sink is operating properly, final leveling may occur. Ensure that the water stream hits the center of the water dispersion rib that runs along the sink bowl front to back. When this is achieved, tighten down wall bracket hardware and secure lower mounting holes with either the supplied hardware included with the IWC2104 wall carrier (or appropriate hardware if installing onto a braced wall).
-
Page 7: Spare Parts
HWSS2321W-00 USE AND CARE The Medi-flo sink is made from Miranit; a mineral composite with a premium gel coat. Avoid the use of strong acids, paint removing compounds and abrasives. SPARE PARTS Solenoid Valve Mixing Valve Solenoid & Control Programmable #AC17-104 #MEDI-MIX Board Assembly... -
Page 8: Warranty
WARRANTY: If inspection the product confirms that it is defective in materials or workmanship, Franke Kindred Canada Ltd. will, at their choosing, repair or exchange the product during the following periods: Sink, waste fitting and shroud – 2 years Water controls and electronics – 1 year NOTE: In the event of a limited warranty claim, proof of purchase date will be required.