Page 3
WALL OPENINGS LAYOUT DISPOSITION DES OUVERTURES DANS LE MUR A. UTILITIES / ALIMENTATION SUPPLY LINES 4 [102 mm] SINK & SHROUD OUTLINE CONDUITES D'ALIMENTATION CONTOUR DE L'ÉVIER & LA JUPE 1 1/2 WASTE LOCATION EMPLACEMENT DE GFI OUTLET LOCATION L'ÉVACUATION 1 1/2 po EMPLACEMENT DE LA PRISE PROTÉGÉE PAR UN GFI 20 1/2 [521 mm]...
Page 8
SIGNAL LINE CONNECTOR CONNECTEUR DE LIGNE WATER OUTLET SORTIE D'EAU DE SIGNAL WATER INLET ARRIVÉE D'EAU AHWSS1720WIS-00_#V1 1221...
Page 9
Connect the signal line to the Connect G 1/2" water supply Connect water outlet hose from control box. hose to the water inlet. spout to control box. Secure Connectez la ligne de signal au Connectez le tuyau d'alimentation with clamp. boîtier de commande.
Page 10
Set sensor range (if necessary) To set the sensor range, hold down the red reset button on the right hand side of the control box for 3 seconds. Place a hand in front of the sensor at a distance where you want the water flow to trigger.
TROUBLESHOOTING / DÉPANNAGE GENERAL CLEANING / NETTOYAGE GÉNÉRAL Use only soap, water and a soft cloth for cleaning. Clean sensor lens with non-abrasive materials only. Nettoyer uniquement à l'eau savonneuse avec un linge doux. Nettoyer la lentille du capteur, uniquement avec un produit non abrasif AHWSS1720WIS-00_#V1 1221...