Franke HWF05 Instructions Manual

OZO-FLO FAUCET AND HOUSING
INSTALLATION
INSTRUCTIONS FOR HWF05, HWF23, HWF43
Preface
Ozonated water has been proven as a safe and extremely effective way to help sanitize the sink and keep the drain and trap free of CPOs
and other pathogens. This also improves the efficiency of hand washing. Other control features include a post-wash cycle of 3 seconds
which ensures all soap residue and bacteria has been washed down the sink, and a daily purge cycle to prevent stagnant water in the lines
and ensure continuous waste disinfection. Any standard P-trap will be disinfected with this process.
Ozo-flo has been exclusively designed for sinks intended for hand washing only. It is not recommended as a drinking source. Recommend-
ed for areas with normal water conductivity in the range of 75 - 350 total dissolved solids (TDS). If unaware of your local water conductiv-
ity, please contact customer service and this can easily be determined for you before you install the product.
Ozo-flo is recommended to be installed with a thermostatic mixing valve and set to a temperature of 27-35C. (Optional accessory MEDI-
MIX is available from Franke).
INSTRUCTIONS:
a) Install the faucet onto the sink or wall
b) Determine the optimum location for the
wall housing - under or near the sink.
Ensure that cable connections can be
made.
c) Using the white wall plate as a template,
mark the screw hole locations (4)
Figure C.jpg
02/22 | OZOZMI-02-2022 | OZO-FLO FAUCET installation
d) Using hardware appropriate for the
installation wall, place the white backing
plate behind the stainless steel plate
and secure to the wall.
Figure D.jpg
e) Use a standard 1/2" braided faucet
supply hose, connect this to the brass
threaded inlet of the solenoid valve.
Figure E.jpg
1