Automatic Electrode Cleaning - Panasonic TK-AS700 Operating Instructions Manual

Automatic Electrode Cleaning

If the above message is displayed...
Start timing of automatic electrode cleaning
After every 10 times
or approx. 10 liters
use of alkaline ion
water and weak acidic
water combined
Automatic Electrode Cleaning
(50 seconds max)
 Do not run water until the cleaning is completed.
 Even if disappears, water may come out from the drain hose.
 Water may drip from the main spout. It is not a malfunction. (This is water remaining in the outlet pipe.)
 The automatic electrode cleaning is not performed for 10 minutes after alkaline ion water level 1 to 3 is used.
TK-AS700_En.indb TK-AS700_En.indb 31 31
Automatic electrode cleaning is performed to
remove calcium deposited on the electrode plate
Wait for a while.
 Do not remove the power plug.
 Water coming out of the main spout and drain hose during automatic electrode
cleaning cannot be used. (The water has been used during cleaning.)
 The electrode plate is located in the electrolyzer inside the main unit. Removing
the calcium prevents deterioration of electrolysis capability.
After every
use of weak
acidic water
When the faucet
is turned off
The countdown is displayed.
Water come
out from the
drain hose
When the Alkaline Ionizer has not been
used for 24 hours
When water is fl owed after
selecting alkaline ion water or
purifi ed water...
Automatic Electrode Cleaning
(Approx. 10 seconds)
The countdown is displayed.
After the cleaning is completed,
and the water quality signal changes to blue or green.
When a buzzer beeps, you can use the product.
 Do not stop water fl ow until the cleaning is completed. If the water fl ow
is stopped, the same operation repeats next time water is fl owed.
Buzzer beeps
from the start
(about 3
seconds)
From main
spout and
drain hose
blinks,
EN31
2022/06/23 2022/06/23 14:07:59 14:07:59