LevelOne WBR-6002 User Manual page 25

Setup
SSID 1/2
Broadcast
SSID
Isolation within
SSID
Security Set-
ting
Configure SSID
1/2 Button
Options
802.11 Mode
Channel NO.
Isolation
between SSID
WMM Support
Bandwidth
This is also called the "Network Name".

If using an ESS (Extended Service Set, with multiple access
points) this ID is called an ESSID (Extended Service Set
Identifier).

To communicate, all Wireless stations should use the same
SSID/ESSID.
If enabled, the Wireless ADSL Router will broadcast its SSID.
This allows PCs and other wireless stations to detect this Access
Point and use the correct SSID.
If disabled, PC users will have to manually enter the SSID and
other details of the wireless interface before they can connect to
this Access Point.
If Enabled, devices that have the same SSID will not be able to
see each other.
The current Wireless security is displayed. The default value is
Disabled.
Click this button to access the Wireless security sub-screen, and
view or change the settings. See the following section for details.
Select the desired mode:

Off - Wireless is disabled.

B only - Only 802.11b connections are available. 802.11g
Wireless Stations will only be able to use the Wireless Rou-
ter if they are fully backward-compatible with the 802.11b
standard.

G only - Only 802.11g Wireless stations can use the Wire-
less Router.

N only - Only 802.11n Wireless stations can use the Wire-
less Router.

11b/g/n - 802.11.g, 802.11b and 802.11n Wireless stations
can use the Wireless Broadband Router.
Select the Channel you wish to use on your Wireless LAN.

If you experience interference (shown by lost connections
and/or slow data transfers) you may need to experiment with
different channels to see which is the best.

If using multiple Access Points, adjacent Access Points
should use different Channels to reduce interference.
If Enabled, devices that have the different SSIDs will not be able
to communicate with each other.
Enable by default.
Select the desired bandwidth from the list.
22