Advertisement
System Setup
The system is a standalone unit with an embedded Linux operating system in the NVR. To
configure the operating system, connect a keyboard, mouse and monitor with HDMI or VGA
input.
1.
Install antennas for cameras and NVR.
2.
Connect a monitor via HDMI or VGA.
3.
Connect the NVR to power (use the larger 12V 2A power adaptor).
4.
Connect the cameras to power (use the smaller 12V 1A power adaptors).
5.
The camera feed will display within a few seconds.
6.
Connect the included USB mouse to a USB port on the rear of the unit.
Hard Drive Replacement
•
Unplug NVR, unscrew & remove top
cover.
•
Remove HDD.
Keep HDD in position and screw in holes
from underneath the NVR to secure it in
place.
Connect SATA power + data cables from
NVR to new HDD.
Replace top cover.
Advertisement
