Pure Fun 9008SJ Manual page 8

ASSEMBLY INSTRUCTIONS
To assemble the trampoline properly, you must follow all instruction steps below. Do not attempt to alter any trampoline frame
components or parts or skip any steps below. Use gloves to protect your hands from pinch points during assembly.
1
(1)
INSIDE
(12)
(11)
(13)
(10)
8
(2)
(12)
(11)
(13)
(10)
GQBrands.com
NOTE: Make sure that you assemble the
T-Section/Legs to the Top Rail as shown
to be certain that the pre-drilled spring
holes are facing in the correct direction
when you attach the springs.
STEP 1:
A. Slide a T-Joint (Part 2) onto the end of a
Top Rail (Part 1). Next, slide the end
of another Top Rail into this T-Section
so that each Top Rail can be bolted to
one side of the T-Section.
NOTE:
Make sure that the Solid Edge of the
T-Section is facing away from the center
of the circle for each Top Rail Section.
B. Fasten the T-Joint to the Top Rails
using 2x Bolts (Part 10), 2x plastic
washers (Part 13), and 2x Hex Nuts
(Part 11)
NOTE: Do not fully tighten the bolts
until all Top Rails are connected.
Repeat these steps with all Top Rails
and all T-Joints to form the Top Rail
Frame.
Once the Top Rail Frame has been
formed, tighten all hex nuts and place
12x Safety Nut Caps (Part 12)
CustomerService@GQBrands.com 1-866-498-5269