Mercedes-Benz A Series Owner's Manual page 300

!
Engine oils for vehicles without a diesel
particle filter may also be used temporarily
Capacities
The following values refer to an oil change including the oil filter.
Engine with oil filter
A 150 BlueFFICIENCY
Replacement amount
Engine with oil filter
Replacement amount
Coolant
The coolant is a mixture of water and anti-
freeze/corrosion inhibitor. It performs the
following tasks:
anti-corrosion protection
R
antifreeze protection
R
raising the boiling point
R
i
When the vehicle is first delivered, it is
topped up with a coolant that will ensure
adequate antifreeze and corrosion protec-
tion.
in vehicles with a diesel particle filter if the
engine oil listed is not available. You must
A 150
A 170 BlueFFICIENCY
5.0 l
A 160 CDI
A 160 CDI BlueFFICIENCY
5.8 l
!
Only top up with coolant that has been
premixed with the desired antifreeze pro-
tection. You could otherwise damage the
engine.
More information on coolant and refilling
can be found in the Mercedes-Benz Speci-
fications for Service Products, sheet no.
310.1 and is available from any Mercedes-
Benz Service Centre.
A 170 A 200
5.0 l 5.0 l
A 180 CDI
5.4 l
Technical data
Service products and capacities
then have an oil change carried out as soon
as possible.
A 200 TURBO
5.0 l
A 200 CDI
5.4 l
!
Always use a suitable coolant mixture,
even in countries where high temperatures
prevail.
Otherwise, the cooling system will not be
sufficiently protected from corrosion, and
the boiling point will be too low.
If antifreeze/corrosion inhibitor is present in
the correct concentration, the boiling point of
the coolant will be around 130 °C.
The antifreeze/corrosion inhibitor concentra-
tion in the cooling system should:
Z
297