Advertisement
To disassemble the slot 2 S.E.C. cartridge
Using the instructions in the Intel S.E.C. Cartridge Disassembly
2
Application Note, insert a 1/8" small flat blade screwdriver between
the cover and the thermal plate, next to one of the four barbed posts
located at each corner of the thermal plate. Twist the screwdriver
until the barbed post pops free. Repeat this procedure for the other
barbed post at the same end of the cartridge, then repeat for the
other end of the cartridge.
Disassembling the S.E.C. Cartridge
Using the instructions in the Intel S.E.C. Cartridge Disassembly
3
Application Note, separate the tabs on the thermal plate away from
the locator pins with fine-tip round nose pliers. Remove the spring
retainer clips, then separate the thermal plate from the processor
card.
Remove any excess thermal grease from the processor heat spreader.
4
Do not allow any thermal grease to get on the pads on top of the
C A U T I O N
microprocessor. The thermal grease could create an open electrical
connection between the probe head and the microprocessor.
8
Advertisement
