Advertisement
������� ���� key can also close and lock the roller
blind in the closed position. If the ������� ���� key
is pressed and left in the �� position, the controller will
close the roller blind and will not allow for its opening
until the ������� ���� key is released (other inputs
will then be locked). This function allows you to lock the
roller blinds e.g. when the alarm is armed or when the
rainfall (if the additional STR-R rain sensor is used) or
too strong wind (if the additional STR-W wind sensor is
used) is detected.
Mounting
1. Disconnect the power supply.
2. Mount the controller on the rail in the distribution box.
3. Connect the controller accordingly to the selected scheme of
operation.
The controllers can be powered from any phase of the
mains (also in the case of a multiple controllers oper-
ating under common central control). It is important to
retain a common N line and to control inputs by the level
of the neutral N line.
Both power cables and control cables must be properly
shielded adequately to the voltage.
4. Switch on the power supply.
5. Program the time of lifting/lowering the roller blind.
- 4 -
Advertisement
