Table of Contents
Advertisement
Crime Guard
The doorlock interface needed will depend upon the type of power doorlocking
system the vehicle is equipped with. Note: The vehicle must have existing
power doorlocks. The addition of a power doorlock interface to a vehicle
without power locks will not allow the security system to operate the doorlocks.
However, power doorlocks may be added to the vehicle in the form of adding
a model DS-2 actuator to each of the doors, along with a doorlock interface.
This configuration will allow the security system only to operate the doorlocks
through the DS-2 actuators.
This security system features a plug-in port for the optional doorlock interface
along with a 4-pin 2-wire connector that plugs into the system's control module
which supplies a negative pulse for locking the doors and a negative pulse for
unlocking the doors.
TM
Power Doorlock Interfaces
1. Green: (-)Lock Pulse
2. Red: Constant 12 Volt (+)*
3. Blue: (-)Unlock Pulse
DLR-1 Relay Pack
Optional
1. Pink: (-)Unlock #2 (2nd Press)
2. White/Black: Pin #87a On Lock Relay
3. Green/Black: Pin #30 On Lock Relay
4. Violet/Black: Pin #87 On Lock Relay
5. Brown: Pin #87a On Unlock Relay
6. Blue: Pin #30 On Unlock Relay
7. Violet: Pin #87 On Unlock Relay
• View From Wire Insert Side
* Red Wire Used Only To Power Coil On Relays.
1 2 3 4
2
328i
1 2 3 4 5 6 7
17
Advertisement
Table of Contents
