Table of Contents
Advertisement
GRAY WIRE - (Negative Auxilary Output): The function of the Gray
wire is to provide an (-)250ma auxiliary output which may be used to
operate a trunk release, car-start module, or window roll-up interface.
To activate the auxiliary channel:
Press & hold the upper Small button for 3 seconds
-The Grey wire will provide a (-)ground pulse for 1 second or remain
grounded for as long as the upper Small button on the transmitter is held
pressed. (Maximum of 15 seconds)
Connection:
1) Connect the Gray wire to pin (#85) of the external relay.
2) Connect Constant (+)12 Volts to pin (#86) of the external relay. (Fused)
3) Connect pins #87, 87a & 30 as indicated in the diagram below:
Note #1: The auxiliary output can be activated anytime the vehicle's
ignition key is turned "Off" and system is disarmed, or in Valet. The
auxiliary channel can also be activated while the vehicle's ignition key is
"On" as long as a door is open. This prevents the auxiliary output from
being activated accidentally while driving.
Warning: If application requires more than a 250ma a relay must be used.
Wiring An Optional Relay For Trunk Release.
Connect To (+)12 Volts Or (-)Negative Ground As Needed in the
particular application. (In This Case Negative Is Required)
To (+)12 Volt
Positive
Release
Switch
Note: In Some Applications The Solenoid Wire Will Rest At Ground.
-Cut The Wire:
-Connect The Switch Side To Relay Pin 87a.
-Connect The Solenoid Side To Relay Pin 30.
-Connect (+)12 Volts To Relay Pin 87. (Fused)
87
86 87a
85
30
12
Gray Wire
Control
Release
Solenoid
Unit
To (+)12 Volt
Positive
Advertisement
Table of Contents
