Lenovo ThinkPad Z60t 2513 Hardware Maintenance Manual page 66

Symptom-to-FRU index
Symptom or error
1820
More than one external
fingerprint reader is attached.
Power off and remove all but
the reader that you set up
within your main operating
system.
2000
Hard Drive Active Protection
sensor diagnostics failed.
Press <Esc> to continue.
Press <F1> to enter SETUP
2010
Warning: Your internal hard disk
drive (HDD) may not function
correctly on this system. Ensure
that your HDD is supported on
this system and that the latest
HDD firmware is installed.
2100
Initialization error on HDD0
(Main hard disk drive)
2102
Initialization error on HDD1
(Ultrabay hard disk drive)
2110
Read error on HDD0 (Main
hard disk drive)
2112
Read error on HDD1 (Ultrabay
hard disk drive)
62
MT 2511, 2512, 2513, 2514
FRU or action, in sequence
Remove all but the reader
that you set up for the
authentication.
1. Undock docking station or
port replicator if it is
attached to the ThinkPad
computer, and place the
computer on a horizontal
surface. Do not apply any
physical shock to the
computer.
2. Run Diagnostics -->
ThinkPad Devices --> HDD
Active Protection Test.
Inform the following information
to the customer:
If in the primary bay the
customer is using a non-IBM or
non-Lenovo hard disk drive
(HDD), or an old generation
IBM HDD which is not
supported by this system, with
the risk in mind, the customer
can still use it by pressing ESC.
If in the primary drive bay the
customer is using a supported
IBM/Lenovo HDD with an old
firmware, the customer needs
to update its firmware to the
latest. The latest version is
available at
http://www.lenovo.com/think/
support
1. Reseat the hard disk
drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk
drive.
2. Ultrabay hard disk drive.
3. System board.
1. Reseat the hard disk
drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk
drive.
2. Ultrabay hard disk drive.
3. System board.