Cleaning - Monthly - Dualit ESPRESSIVO Instruction Manual & Guarantee

CLEANING – MONTHLY
BEFORE CLEANING, ENSURE THAT THE APPLIANCE IS
SWITCHED OFF, UNPLUGGED AND ALLOWED TO COOL.
Risk of electric shock and scalding. Do not wash any of the
plastic accessories or Filter Holder in the dishwasher.
*If you have trouble removing the Nozzle, call Customer Services
on 01293 652500. Use a pin to ensure that the Steam Nozzle is not
blocked.
1 WIPE BREWHEAD 2 UNSCREW
Wipe the entire Brewhead Using a screwdriver and
area and external surfaces hammer, gently tap the
to ensure it is completely screw to dislodge any
free of coffee grounds. Fine dried coffee. Then unscrew
coffee grounds can block the clockwise (when viewed
Shower Head. from above).
4 FILTER BASKET 5 RINSE FROTH
NOZZLE
Unscrew using a Philips ph2 Ensure that the Froth
screwdriver to separate Nozzle is cool before
Filter Basket components. cleaning. Pull the Froth
Use a pin to clear holes and Nozzle off the Steam Wand
grooves, and clean with a and wash under running
soft brush. Dry, then carefully water to remove any milk
residue. Risk of burns.
reassemble. Note: Do not
overtighten the components
during reassembly
3 CLEAN
BREWHEAD
Use a pin to clear holes and
grooves, and clean with a
soft brush. Dry, then use a
screwdriver to reinstall the
Showerhead.
UNSCREW
6
Unscrew Steam Nozzle in a
clockwise direction (when
viewed from above) to
remove from the Steam
Wand. Do not apply
excessive force. *
22
7 CLEAN STEAM 8 CLEAN THE
WAND HANDLE STEAM WAND
Support the Steam Wand Use a pin to remove dried
then pull the Steam Wand milk from inside the Steam
Handle down to remove. Wand.
Note: Steam Wand Handle
is tightly fitted and may need
extra time and attention to
remove. Clean Steam Wand
Handle with detergent and a
cleaning brush.
REINSTALL FLUSH STEAM
10 11
STEAM/FROTH WAND
NOZZLE
Reinstall Steam Nozzle by IMPORTANT NOTICE:
screwing it anticlockwise Turn on your machine.
into the Steam Wand (when Flush the Steam Wand by
viewed from above). Then dispensing water, this will
push the Froth Nozzle remove any milk residue
upwards onto the Steam from inside the Steam Wand
and prevent blockages. Risk
Wand to install.
of scalding.
9 REINSTALL STEAM
WAND HANDLE
Reinstall the Steam Wand
Handle by aligning the
Steam Wand Handle with
the Steam Wand and
pushing it upwards. Note:
the Steam Wand Handle is
tightly fitted and may need
extra attention and time to
attach.
WATER TANK
12
Empty and rinse the Water
Tank and refill with fresh
water.
23