Operation; Aiming The Headlights - Toro Groundsmaster 5900 Series Installation Instructions Manual

9
Verifying that the Machine
is in CE Mode
No Parts Required
Procedure
1. Start the machine.
2. From the InfoCenter main menu, navigate to the
About screen (Figure
Figure 26
3. Verify that the machine is in CE mode. If it is not in
CE mode; contact your Authorized Service Dealer
(Figure 27)
26).

Operation

Using the Light and Hazard
Switches
•
Turn the key switch on and press the light switch to the
O position to activate the head lamps.
N
•
Press the hazard switch to the O
front and rear flashing hazard lights.
•
Turn the key switch on and press the left side of the turn
signal switch to activate the left turn signal and the right
side of the switch to activate the right turn signal. The
g188853
center position is off.
Note: Check the operation of the lights. Make sure that
the correct lights are flashing when operating the turn
signal switch.

Aiming the Headlights

1. Loosen the mounting nuts to adjust the lights.
2. Adjust the lights per local standards.
12
Figure 27
position to activate the
N
g188852