Lenovo ThinkCentre M58 6239 User Manual page 32

Figure 14. Installing the retainer
Figure 15. Installing the drive
10. Continue at "Connecting a SATA drive."
Connecting a SATA drive: A SATA optical drive or a SATA hard disk drive can
be connected to any available SATA connector on the system board.
1. Locate the signal cable that comes with the new drive.
2. Locate an available SATA connector on the system board. See "Locating parts
3. Connect one end of the signal cable to the drive and the other end to the
24
User Guide
6. For a 5.25-inch drive, install the retainer on the side of the drive.
7. For a 3.5-inch drive, you must use a Universal Adapter Bracket, 5.25 to
3.5-inch. You can obtain a Universal Adapter Bracket, 5.25 to 3.5-inch from a
local computer retailer or by contacting the Customer Support Center. Install
the retainer on the side of the Universal Adapter Bracket.
8. Install the drive into the bay.
9. To reinstall the front bezel, align the plastic tabs on the right side of the front
bezel with the corresponding holes in the chassis, then pivot the front bezel
inward until it snaps into position on the left side.
on the system board" on page 11.
available SATA connector on the system board.