Frequently Asked Questions - Car Keys Express GMRM-6THZ1RE User Manual

1. Find your vehicle's make, model, and year in the COMPATIBILITY LOOKUP
on page 3. Turn the dial on the EZ Installer to the position listed for your
vehicle's make, model, and year.
NOTE: One working key should be present during the pairing process.
2. Begin with the vehicle in PARK and the engine OFF.
3. Enter the vehicle and close all doors.
4. Insert the key into the ignition and turn the key to the ON position. This
should be the position before starting the vehicle, see below. DO NOT start
the vehicle
5. Remove the security label from the EZ Installer and insert it firmly into
the on-board diagnostic (OBD) port located under the dash.
a. The location of your vehicle's OBD port can be found in the
owner's manual.
6. The EZ Installer will beep twice when it powers up and starts the process.
7. The EZ Installer will sound a short tune when programming mode has
started.
a. Your vehicle may or may not provide feedback such as the door
lock cycling, a message on the dashboard, or a chime.
8. After hearing this short tune, press and hold both Lock and Unlock on your
new remote for approximately 15 seconds.
9. Repeat step 8 for each additional remote to be programmed.
10. After all remotes have been added, turn the key to the Off position and
unplug the EZ Installer.
11. Press buttons on each remote to test they were properly programmed to
the vehicle.*
*Some vehicles may need to have the engine started and stopped, and the
driver's door opened and closed before the remotes will work.
Q: Can I use the same EZ Installer on other vehicles?
4
USER GUIDE

FREQUENTLY ASKED QUESTIONS

GM IGNITION POSITIONS