Frequently Asked Questions - Car Keys Express Simple KEY User Manual

SIMPLE™ KEY USER GUIDE
3. Begin with the vehicle in PARK and the engine OFF.
4. Turn hazard lights ON.
5. Insert the original key into the ignition and start the vehicle.
6. Remove the security label from the EZ Installer™ and insert it firmly into the on-board diagnostic (OBD) port
located under the dash.
a. The location of your vehicle's OBD port can be found in your owner's manual.
7. Wait up to 8 seconds and listen for 3 quick beeps from the EZ Installer™.
a. NOTE: If you hear a series of more than 3 rapid beeps, an error has occurred. Please see FAQs to learn more.
8. Turn the ignition off and remove the key.
9. Insert the new key and turn the ignition to the ON/RUN position.
CDJ IGNITION POSITIONS
10. To continue, press and release the EZ Installer™ button.
11. Wait up to 8 seconds and listen for 3 quick beeps from the EZ Installer™.
NOTE: If you hear a series of more than 3 rapid beeps, an error has occurred. Please see FAQs to learn more.
a.
12. Turn the ignition off and remove the key.
13. To continue, press and release the EZ Installer™ button.
14. The EZ Installer™ will chime when pairing is complete.
10
SIMPLE™ KEY USER GUIDE
15. Unplug the EZ Installer™. If the EZ Installer™ is left in the OBD port for more than 5 minutes, an alarm will sound, reminding you
to remove it.
16. To pair additional keys, unplug the EZ Installer™ from the OBD port and reinsert it. Repeat the pairing process for any
additional keys, beginning with PAIRING STEP 1.
17. Test all keys.
18. Turn hazards off.

FREQUENTLY ASKED QUESTIONS

Q: The EZ Installer™ beeps 8 times after pushing the button to initiate the pairing process and will not pair the new key.
A: Your vehicle allows a maximum of 8 paired keys. If the vehicle already has 8 keys paired to it, a new key cannot be
paired. If the EZ Installer™ beeps 8 times early in the pairing process, this indicates that the maximum number of keys
have been paired. Please contact Car Keys Express customer service at 888-598-8910.
Q: Can I use the same EZ Installer™ on other vehicles?
A: No, the EZ Installer™ will be locked to the first vehicle it is used on. You may add more keys to the same vehicle
again as needed, but it will not work on different vehicles. If the EZ Installer™ sounds 2 beeps at 1 second intervals, then
beeps rapidly, this signifies that the device has already been used on another vehicle. Visit CKESimpleKey.com or your
local retailer to purchase additional keys.
Q: The EZ Installer™ sounds 2 or 3 beeps at 1 second intervals 3 times then beeps continuously.
A: When problems occur during the pairing process, EZ Installer™ will beep an error code, followed by continuous faster
beeps. The number of error beeps correspond to specific error codes, as explained below.
11