Removing And Reinstalling The Front Bezel - Lenovo ThinkCentre A58e 0841 Hardware Maintenance Manual

Removing and reinstalling the front bezel

This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel, do the following:
1. Remove the computer cover. See "Removing the computer cover" on page 83.
2. Remove the front bezel by releasing the three plastic tabs on the left side and
Figure 2. Removing the front bezel
84
Hardware Maintenance Manual
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
pivoting the front bezel outward. Carefully set the front bezel to the side
without disconnecting the power switch/LED (Light-emitting Diode) assembly
cable.
Note: If you are replacing the front bezel, disconnect the power switch/LED
assembly cable, then completely remove the front bezel off the chassis.