Advertisement
Insert the original key and turn the ignition to the ON/RUN position. If there are no markings, turn the key
5.
clockwise and stop just short of starting the engine.
6.
Press and release the EZ Installer™ button. You will hear a short beep.
a.
NOTE: If you hear a series of 5 quick beeps, this indicates that the maximum number of keys have been paired,
and an error has occurred. Please see FAQs to learn more.
7.
Wait 30 seconds, the EZ Installer™ will beep twice. You will then have 12 seconds to complete the next step (step 8).
Remove the original key and insert the new key into the ignition. Do not turn the key. Then, press and release the
8.
button on EZ Installer™.
NOTE: If you do not complete this step in 12 seconds, the EZ Installer™ will beep continuously, and an error has
a.
occurred (see FAQs for more information). Unplug the device, remove the key, and begin again at Step 1. If you
do not hear any sound, you have started the pairing process. Continue below.
9.
Wait 60 seconds. When pairing is complete, the EZ Installer™ will beep 3 quick, different pitch beeps.
10.
To pair additional keys, repeat the pairing process for any additional keys, beginning with KEY PAIRING STEP 5.
11.
Leave the EZ Installer™ plugged into the OBD port and continue to STEP 2 (of 2) REMOTE PAIRING.
a.
NOTE:: If you are not pairing a remote, or your key does not have remote functions, unplug the EZ Installer™. If
the EZ Installer™ is left in the vehicle's OBD port for more than 20 minutes, an alarm will sound reminding you
to remove it.
12.
To test the new key, start the vehicle.
SIMPLE™ KEY USER GUIDE
TOYOTA IGNITION POSITIONS
7
Advertisement
