Advertisement
Q: The new key won't pair to my car.
A: If the EZ Installer™ doesn't pair the key to your car, most likely an incorrect dial position was used. In this case,
the EZ Installer™ will beep continuously after you press the pairing button. Check the compatibility section on
pages 4-5 to confirm the correct dial position for your make, model, year, and transponder chip of your original
key. If an alternate dial position(s) is listed for your vehicle, unplug the EZ Installer™, turn the knob to the alternate
position, and try pairing again. If the key still won't pair, please contact customer service at 888-598-8910.
Q: The EZ Installer™ was unplugged during the pairing process.
A: The EZ Installer™ must remain plugged into the on-board diagnostic (OBD) port until pairing is complete. If the
EZ Installer™ becomes unplugged during the pairing process, turn the ignition to the OFF position, remove the
key, and begin the pairing process again.
Q: The vehicle won't start with the new key or old keys after attempting to pair.
A: Please call Car Keys Express customer service at 888-598-8910.
TRANSPONDER CHIP: DOT
MODEL: RT-TOY-A or 12BBY
FCC ID: 2AOKM-TOY-V1 or HYQ12BBY
IC: 24223-TYV1 or 1551A-12BBY
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
SIMPLE™ KEY USER GUIDE
FCC AND ISED REGULATORY STATEMENT
TRANSPONDER CHIP: H
MODEL: RT-TY54B or 12BDM
FCC ID: 2AOKM-TY5 or HYQ12BDM
IC: 24223-TY5 or 1551A-12BDM
15
Advertisement
