Advertisement
Machine Translated by Google
In such a case
can't play
The number of tracks, etc., is not displayed even
when a CD is inserted.
C
D
Certain parts cannot be played.
FM reception is poor. There
is a lot of noise or distortion.
I can't receive AM well. A lot
of noise.
Radio
I cannot receive TV broadcasts.
Remote control does not work.
Remote controller
Memory reset (initialization)
In the following cases, reset (initialize) the
memory according to the procedure on the right.
Nothing responds when I press the button. I
want to erase the contents of the memory and set it again.
check here
• Is the CD upside down? • Are you using a
non-standard CD?
If the CD is badly bent or scratched, it cannot be used.
Condensation may form on the lens when suddenly brought
from a cold place to a warm place. Please wait for about
an hour.
If the CD is dirty, wipe it with a soft cloth.
Try changing the length and orientation of the whip
antenna. If your TV, VCR, BS tuner, etc. are on, try turning
them off.
If the transmitting station is far away, or inside a steel-reinforced
building, the signal will be weak. Install in a location with favorable
conditions, such as by a window.
• Is an AM loop antenna connected? • Try changing
the direction or position of the AM loop antenna.
please.
If your TV, VCR, BS tuner, etc. are on, try turning them off.
If there is a power cord near the antenna cord, move it
away.
Is your radio on FM? The TV can only
receive audio from channels 1 to 3 via FM.
• Is the battery inserted in the opposite direction? •
If the batteries are exhausted, replace them with new ones.
Are there any obstacles between you and the machine?
• To reset (initialize) the contents of memory
ÿ Remove the power plug from the outlet. (Leave for 3 minutes or
longer.)
ÿ While holding down [POWER ] on the main unit ÿ
Insert the power plug into the outlet
ÿRelease [POWER ] when "------------" is displayed on
the display •When the memory is reset (initialized),
high- speed recording cannot be used until about 74 minutes
later. It is necessary to reset the clock, broadcasting
station, etc.
Is it
a
Reference page
12
47
malfunc
47
7
7
when needed
15
7
7
51
RQT6010
Advertisement
