Advertisement
Machine Translated by Google
various recordings
Before
operation •Insert the MD for
recording into the unit. • Select the long mode of MD according to your needs. (page 43)
Recording a CD to an MD at high speed (up to 4x speed) (CD high-speed recording)
ÿ To stop recording halfway: Press [ÿ]. ÿTo
stop the recording end confirmation sound: Press [ÿ] while the confirmation sound is sounding.
news
The volume of the confirmation tone at the end of recording
cannot be adjusted. To switch on/off , press and hold [CANCEL, BEEP] .
Digital signals are recorded from CD to MD. High-speed recording
from a radio, external device connected to the [P-MD/AUX] terminal, etc. other than the CD of this unit is not possible. It is not
possible to monitor the sound during high-speed recording. "MUTING VOLUME" is displayed when the volume is adjusted. You cannot
pause during high-speed recording. Depending on the source (sound source), an error may occur in the recording time.
ÿ High-speed recording mode
Normal
recording ( page 16)
CD whole recording •
CD 1 song aim recording •
CD analog recording ×
Ookkake recording
Program recording ×
Recording when repeat setting ×
Recording at random setting ×
please
Do not open the CD lid while recording or immediately after inserting a CD and closing the CD lid.
26
Doing so may scratch the CD.
RQT6010
insert a CD
CANCEL
DEMO
BEEP
DUAL
HI SPEED
Recording starts, and when it ends,
a confirmation sound (beep tone)
sounds and stops.
Restrictions on high-speed recording of CDs
•
to MDs There are the following restrictions for copyright protection.
High-speed recording from the same CD is not possible for approximately 74 minutes after high-speed
recording ends. High-speed recording from the same CD is not possible for approximately 74 minutes after
stopping high-speed recording. After recording the first CD at high speed, within about 74 minutes, 24 different
You can record CDs at high speed, but you cannot record the 25th CD at high
speed. After resetting (initializing) the memory ( page 51), high-speed recording is not possible
for approximately 74 minutes. During high-speed recording, it is not possible to place track marks
at desired positions.
×
ÿIf "PLEASE WAIT, •• min" is displayed , please wait for ••
minutes. (See above.) ÿ If "HIGH-SPEED, CAN NOT REC"
is displayed , high-speed recording such as program, repeat, random, and
trick recording cannot be performed. Please record according to the method marked • in the
table on the left.
Press to switch to CD
until the display on the right is displayed.
keep pushing
< C D >
REC
MD
< HIGH SPEED >
REC
MD
CD 1 0:05
MD REC
BEEP ON
BEEP OFF
Advertisement
