Replacing The Light Bulb - Baumatic TITAN1 Instruction Manual

o Remove the drawers and shelves from the freezer section and
o You can use a sponge to mop up the defrost water that will run
o IMPORTANT: You should place some old towels on the flooring
o Once all the ice that has built up has melted, then the inside of
o With dry hands, reconnect your appliance to your mains supply.
o You should not attempt to freeze fresh food inside the freezer
o Do not defrost the appliance with other electrical devices

Replacing the light bulb

Fridge section
The light bulbs can be found behind the light cover at the top of the
fridge section (below the control panel).
Get user manuals: See SafeManuals.com
leave the door to the freezer compartment open. You can place a
bowl of warm water inside the freezer compartment to speed up
the defrost process.
into the bottom of the freezer section.
that is immediately in front of the appliance. In case any defrost
water comes out of the freezer section and onto the floor.
the freezer compartment should be dried thoroughly. Failure to
do this will result in immediate ice build when the appliance is
turned back on.
You should select the coldest freezer setting (number 5) for a 24
hour period, before returning it to the normal temperature
setting of number 3.
compartment until this 24 hour time period has elapsed.
(e.g. hair dryer). Do not use sharp metal objects to
remove the ice on the freezer, as this could cause damage
to the refrigerant system.
WARNING: PLEASE ENSURE THAT YOUR
APPLIANCE IS DISCONNECTED FROM
YOUR MAINS SUPPLY BEFORE
ATTEMPTING TO REPLACE THE LIGHT
BULB.
1) Remove the screws that hold the light
cover in place.
19