Hartzell HC-E3YR-7 Owner's Manual page 34

(5) Safe Handling of Paints and Chemicals
(a) Always use caution when handling or being exposed
to paints and/or chemicals during propeller overhaul
and maintenance procedures.
(b) Before using paint or chemicals, always read the
manufacturer's label on the container and follow
specified instructions and procedures for storage,
preparation, mixing, and application.
(c) Refer to the product's Material Safety Data Sheet
(MSDS) for detailed information about physical
properties, health, and physical hazards of any
chemical.
(6) Observe applicable torque values during maintenance.
(7) Before installing the propeller on the engine, the
propeller must be statically balanced.
(a) New propellers are statically balanced at Hartzell
Propeller Inc. before being shipped.
(b) Overhauled propellers must be statically balanced
by the overhaul facility before return to service.
(c) Dynamic balance is recommended, but may be
accomplished at the discretion of the operator,
unless specifically required by the airframe or engine
manufacturer.
1 Perform dynamic balance in accordance with the
Maintenance Practices chapter of this manual.
2 Additional procedures may be found in the
aircraft maintenance manual.
(8) As necessary, use a soft, non-graphite pencil or crayon
to make identifying marks on components.
(9) As applicable, follow military standard NASM33540 for
safety wire, safety cable, and cotter pin general
practices. Use 0.032 (0.81 mm) diameter stainless steel
safety wire unless otherwise indicated.
INTRODUCTION
Propeller Owner's Manual
136
61-00-36
Page 1-6
Rev. 2 Feb/17