Hartzell HC-E3YR-7 Owner's Manual page 205

WARNING:
CAUTION:
(6) Apply a sufficient amount of finish coating to achieve 2 to
4 mil thickness when dry.
(a) Re-coat before 30 minutes, or after 48 hours.
(b) If the paint is permitted to dry longer than four (4)
hours, it must be lightly sanded before another coat
is applied.
(7) Remove the masking material from the tip stripes and
re-mask to permit the tip stripe refinishing, if required.
(8) Apply sufficient tip stripe coating to achieve 2 to 4 mil
thickness when dry.
(a) Re-coat before 30 minutes, or after 48 hours.
(b) If the paint is permitted to dry longer than four (4)
hours, it must be lightly sanded before another coat
is applied.
(9) Remove the masking immediately from the anti-icing or
de-ice boot and tip stripes, if required.
(10) Optionally, perform dynamic balancing in accordance with
the procedures and limitations specified in the Dynamic
Balance section of this chapter.
MAINTENANCE PRACTICES
Propeller Owner's Manual
FINISH COATINGS ARE FLAMMABLE
AND TOXIC TO THE SKIN, EYES AND
RESPIRATORY TRACT. SKIN AND EYE
PROTECTION ARE REQUIRED. AVOID
PROLONGED CONTACT. USE IN A WELL
VENTILATED AREA.
APPLY FINISH COATING ONLY TO THE
DEGREE REQUIRED TO UNIFORMLY
COVER THE REPAIR/EROSION. AVOID
EXCESSIVE PAINT BUILD-UP ALONG THE
TRAILING EDGE TO AVOID CHANGING THE
BLADE PROFILE.
61-00-36
136
Rev. 2 Feb/17
Page 6-21