Advertisement
Demo Mode
This is a basic introduction to driveSTUDIO.
Service Interface
This enables the user to run the motor with basic functionality via the
driveSTUDIO software.
Velocity Mode
1.
Ensure the Motor is enabled by setting either INA or INB to High (1)
on the K4 Motor Controller.
2.
Click and hold the Left or Right Icon to run the Motor Clockwise or
Counter Clockwise.
Position Mode
1.
Ensure the Motor is enabled by setting either INA or INB to high (1)
on the K4 Motor Controller.
2.
Enter required rotation, 1 revolution of the motor output shaft =
65535 counts.
Note: - Any gearbox ratio is not accounted for in this calculation
3.
Enter postion figure (+ figure clockwise shaft rotation, - figure
anticlockwise shaft rotation).
4.
Click <<-Relative+>> to activate motor.
Note: - The direction of rotation from the output of the motor shaft. The
direction may be altered if a gearbox is fitted.
6
Advertisement
