Advertisement
driveSTUDIO Connection
1.
Install and open driveSTUDIO Software on PC/Laptop.
(https://www.ebmpapst.com/en/info-center/downloads/downloads.html#listsoftware
2.
Install the supplied RS485 driver software onto PC/Laptop following
the manufacturer's instructions.
3.
Connect RS485 Adapter to PC/Laptop and the K4 Motor Controller–
see wiring diagram 2.
4.
Connect the motor to the K4 Motor Controller.
5.
Connect to Power supply using Power Cables as shown in Wiring
diagram 1 - 24VDC or 48VDC.
Note: – Ensure correct voltage is selected
Note: - Isolated power supply (24v and/or 48v) with minimum 10A rated
should be used
6.
Click the Connect Icon to begin communication with the motor.
)
5
Advertisement
